Tools &
Preparation

Tools

1.1 Fixing kit to install up to 8 door leaves, including a selection of packers 1mm-6mm, 35 4mm x 40mm glazing packers and screws

Allen key

2.5mm, 3mm and 4mm

Battery screwdriver

Drill

SDS with appropriate bits for preferred frame fixings

Drill bits

Appropriate for drilling jamb packers, and lintel
Blade type, or HSS 13mm
Counter-sink
Long series - 3.5mm

Fixings for lintel

Flat bar

Foam gun

Frame packers (mixed selection)

Gasket sheers

Glazing packers

4mm (min. width 32mm)

Glazing paddle

Hammer

Plastic / rubber

Measuring staff

Saw

For cutting aluminium cill

Screwdrivers

Flat head (large)
Philips 2
Pozi 2

Sealant and gun

Self-tapping screws

25mm

Spirit level (long)

Straight edge (long)

String line

Torx

T30 bit and key
¼ inch ratchet

NOTES: If it is necessary to pack the outer frame by more than 6mm, a solid plastic or hardwood packer should be used. Frame cannot be fitted on straps

Preparation

2.1 Measure the opening and check it fits with all measurements on your Origin paperwork

2.2 Carefully unpack the tracks and jambs

NOTE: Jamb Packers not used on any jamb with a fixed sash attached

2.3 On the hinge jamb, place a jamb packer behind each hinge position, and one in the centre between the middle and top hinge. level with each hinge. Secure the jamb packers in place in the back of the jamb by inserting a screw either side

2.4 Repeat this for locking jamb

2.5 On the locking jamb, place a jamb packer 50mm down and 50mm up from the top and bottom of the jamb. With the remaining jamb packers, place one above and one below the centre keep

2.6 Secure jamb packers by inserting a screw either side (FIG 2A)

2.7 Spaced at a maximum of 500mm apart, place the correct frame packers along the length of the opening, creating a level, well supported platform for the track/cill to sit