Handles & Locks
You may need to work out and cut the spindle length and screws to the correct length. The necessary lengths are as follows:
40mm screws for both the handles and turn and release
50mm visible spindle length for the turn and release
90mm spindle length for the handle
8.1 Push the spindle with the spacer into the locking mechanism and push the female ends of the bookend screws into the handle and push these over the spindle
8.2 Push the other half of the handle onto the spindle, pushing the screws through into the female screw ports of the handle - these can then be tightened up, with care taken not to strip the threads
8.3 Tighten up the grub screws on the handle to prevent them from coming loose, then screw the rose covers onto the handle
8.4 This same process applies to fitting the thumb turn lock if supplied
8.5 If you need to adjust the locking of the door, use a flat headed screwdriver to pry the tab on the lock keep to the correct closing and locking operation